Xtreme Power 212 CC, Инструкция по эксплуатации и правила безопасности

Страница: 10 / 24

1. See engine manual for start up instructions.
2. Ensure engine is running full throttle before beginning chipping operation. On some engines, the throttle
may not be adjustable.
STARTING THE ENGINE
1.
See engine manual for shut down procedure.
2.
Stopping the engine is the only way to stop the rotor from turning. With engines equipped with an adjustable
throttle, move the throttle to the SLOW position and wait for engine to be running a slow RPM. Then switch
to STOP ENGINE as shown in the engine manual.
STOPPING THE ENGINE
• Prune branches down close to the main branch to make feeding them into the chipper cone easier.
• Large, hard, dried tree branches that resist chipping can be processed by rotating them as you alternately
insert and retract them.
• If the material to be chipped is extremely hard, kicks back forcefully when being fed into the chipper cone,
or cannot be easily controlled, remove the material immediately and set it aside.
• If additional force is required to insert materials into the chipper, the blades probably need to be
sharpened. Consult the Troubleshooting and Repair section of this manual, or see your authorized dealer.
• Maintain control of the materials you are feeding to prevent them from whipping around.
•
DO NOT insert short pieces of material into the chipper cone by hand. Use a larger piece of material to
feed them into the chipper cone.
CHIPPING TIPS:
Don’t overload the shredder by dumping large volumes of material into the hopper opening.
• Alternate loads of wet and dry material to prevent the discharge from becoming plugged.
• Never use any object to force material into the shredding chamber. It could get caught in the shredding
hammers and damage the unit.
SHREDDING TIPS:
Perform engine maintenance and storage measures listed in the engine owner’s manual. This includes
draining the fuel system, or adding stabilizer to the fuel.
STORAGE
NOTE: DO NOT store a fueled unit in an enclosed structure. (SEE GASOLINE FIRES AND HANDLING
FUEL SAFETY).
Check all fluid levels. Check all maintenance items.
• Perform all recommended checks and procedures found in the engine owner’s manual.
• Allow the engine to warm up for several minutes before use.
BEFORE STARTING THE UNIT AFTER IT HAS BEEN STORED:
9
OPERATION