Walk-behind floor scrubber -www.xtremepolishingsystems.com
Performing regular maintenance according to the Manufacturer's instructions improves
performance and extends the working life of the machine.
When cleaning the machine, respect the following:
·
avoid the use of high pressure washers. Water could penetrate the electrical compartment or
motors leading to damage or the risk of short circuit;
·
do not use steam to avoid the heat warping plastic parts;
·
do not use hydrocarbons or solvents as they could damage the cowling and rubber parts.
9.2.
Routine maintenance
9.2.1 Suction motor air filter and float switch: cleaning
·
Unscrew and remove the tank cap from the dirty water drum;
·
make sure the dirty water drum is empty;
·
clean the float switch at the back of the dirty water drum, taking care not
to direct the water jet directly against the float switch;
·
remove the suction motor air filter from the float switch support in side the dirty water
drum at the top;
·
clean the filter with running water or the detergent solution used on the machine;
·
dry the filter thoroughly before replacing it in the support. Make sure the filter is correctly
located in its housing;
·
screw the cap back on the dirty water drum.
Pic
（
28
）
Pic
（
29
）
Pic
（
30
）
9.3
Detergent filter: cleaning
·
Unscrew the screw located below the bottom tank;
·
unscrew the detergent filter;
·
clean the filter with running water or the detergent solution used on the machine;
·
replace the filter back in its housing, making sure it is correctly positioned and retighten the
screw.
9.4
Squeegee blades: replacing
The squeegee blades collect the film of water and detergent from the floor and prepare the way
for perfect drying. With time, the constant rubbing leaves the edge of the blade
in contact with the floor rounded and cracked, reducing the drying efficiency and requiring it to be
replaced.
Turning or replacing the blades:
