Walk-behind floor scrubber -www.xtremepolishingsystems.com
for perfect drying. With time, the constant rubbing makes the edge of the blade in contact with the
floor rounded and cracked, reducing the drying efficiency and requiring it to be replaced. The state
of wear should be checked frequently.
For perfect drying, the squeegee must be adjusted in such a way that the edge of the rear blade
bends during operation by about 45° with resp ect to the floor at every point. Adjust the angle
of the blade during operation by regulating the height of the two wheels positioned behind the
squeegee.
Tighten the middle nut,will add the angle of squeegee support,make the squeegee closer to
ground.loosen middle nut will make squeegee away from ground.As the picture 18(show)
Picture (18)
Loosen the nut on the squeegee wheel ,will make squeegee wheel away from ground,then
squeegee is closer to ground.tighten the nut,will compress squeegee wheel to ground,then
squeegee is further away from ground. Generally, adjusting nut to make two squeegee wheels
just touch ground is ok.
6.3.
Moving the machine when not in operation
To move the machine, proceed as follows:
1) raise the squeegee;
2) push the head pedal down then to the right to raise the head;
3) move the machine by pulling or pushing
4) once you have reached your destination, lower the head by pressing the release pedal
down and to the left, then release it.
IMPORTANT
Do not leave the machine unattended or parked with the head lifted or the key inserted in
the emergency button.
6.4.
Mounting and changing the brush/drive disks
IMPORTANT
Never work without the brushes and drive disks perfectly installed.
Fitting the brush (one brush version):
Put the brush plate down the brush plate cover,Pick up the brush plate with both hands
