Xtralis ADPRO FastTx, Инструкция по установке и эксплуатации

Страница: 85 / 138

ADPRO FastTx by Xtralis Installation and User Manual
Doc 11949_06
73
QUAD Images Interval
Options: 0.2, 0.3, 0.4, 0.5, 1, 2, 3, 4, 5 seconds
Default: 0.5 seconds
This option allows the user to define the required interval (in seconds) between images being
captured after an alert is generated, for the quad alarm sent to ADPRO VideoCentral.
Camera Terminated
Options: Yes, No
Default: Yes (ticked)
Use the checkbox to define whether the selected channel (camera output) is terminated with a
75 ohm resistance. By default all channels are terminated.
Clear the checkbox when the video cable from the camera is to be connected to the ADPRO
FastTx’s video input via a ‘T-Connector’. In this case, the video may be fed to another piece of
equipment, for example a video switcher or a CCTV monitor.
Caution: Camera termination is only active whilst the ADPRO FastTx is powered. If, for any
reason, the power is removed from a ADPRO FastTx unit, any connected cameras
will become unterminated.
Use Activity Detection
The ADPRO FastTx can be setup to respond to changes that occur within the field of view of a
camera. This feature is used to trigger an alarm if activity is detected by a certain camera in an
area not normally expected to have activity.
To help configure the Activity Detection feature, the sensitivity to movement and the amount of
time that movement occurs can be programmed. This is done by selecting the
Activity
Detection tab.
PTZ Settings
This Camera has a PTZ station.
Options: Yes, No
Default: No
Set the checkbox when this channel is connected to a camera with PTZ (Pan/Tilt/Zoom). The
type of PTZ equipment is set in the
PTZ Settings option (refer to “ PTZ Settings ” on page 70).
If checked, the Configure button will become available. By clicking on the Configure button, the
Alarm Preset Settings may be modified.