The number "
1
" corresponds to the lowest torque value, the number "
25
" corresponds to the
highest value. However, the indicated figures do not correspond to the values in "Nm" - i.e., the
value "1" on the selector is not equal to "1 Nm".
Try the appropriate setting of the tightening or loosening torque on a practice screw/workpiece, or
proceed from smaller values to higher ones until you reach the optimal setting.
TIP!
•
If you are going to tighten a large number of identical screws, take a moment to set the
correct torque. This avoids unnecessary cam out and damage to the bit and the screw
head after the screw is tightened to the required depth. At the same time, you do not need
to watch for the release of the trigger and possible overtightening of the screw, because
the tightening mechanism disengages at that moment.
•
The torque setting only works if the ring selector is in set in "
driving
" mode, i.e., if any
number from 1-25 is selected and set. If the drill symbol is set, the "
drilling
" mode is
selected, the torque clutch is automatically disengaged and the maximum torque value is
preset.
General table for recommended selection of suitable setting according to the material:
Mark
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
Bolt
M4
M5
M6
Screw
Soft
wood
-
Ø 3,5 x 22
Ø 4,1 x 38
-
Hard
wood
-
Ø 3,5 x 22
Ø 4,1 x 38
-
*
the values in the table are only approximate, always choose the appropriate setting based on the
material, application or your own experience
TOOL INSERT / REMOVAL
The chuck (1) is used for clamping various work tools. The advantage of the keyless chuck that
this drill offers, is the ability to clamp tools without using special keys or other tools.
•
Turn the chuck to the right (3 - counterclockwise), which will expand the jaws of the chuck.
Continue turning the chuck until there is enough space between the jaws to insert the given
tool (drill, driver bit, bit holder, etc.).
•
Insert the tool and to fix it, turn the chuck back to the
left
(2 - clockwise) until you feel a
slight resistance - then tighten it firmly.
1. Chuck
2. Turn to tighten the chuck
3. Turn to open the chuck
Содержание XT102705
