SB
550
Fitness Bike
7
1. Install the Rear Stabilizer Tube (
18
) and secure with two Carriage Bolts
(
96
), Curved Washers (
97
) and Cap Nuts (
98
).
2. Sitting next to the unit with the Seat Post (
11
) in your lap, connect the
two wires together (
109
&
110
). Secure the Seat Post to the Main Frame
be careful to not pinch the wires with the six Button Head Socket Bolts
(
95
), Split Washers (
73
) and Flat Washers (
70
).
3. Lay the Seat Cushion (
52
) on the floor, cushion side down, and then lay
the Seat Carriage Assembly (
4
&
14
) on top of the Seat Cushion. Align
the holes and secure the Seat Cushion with four Phillips Head Screws
(
99
). Make sure Seat Cushion is facing the right direction.
4. Secure the Seat Carriage Assembly (
4
&
14
) to the Seat Post with four
Hex Head Bolts (
90
). Make sure these bolts are very tight. Assemble
the plastic end caps (
42
) to the Seat Carriage with four Phillips Head
Screws (
81
).
SB
550
Assembly Instructions
Hardware Step 1
Seat Assembly & Rear Stabilizer
1
#70
. 5/16” x 18mm
Flat Washer (6 pcs)
#73
. 5/16”
Split Washer (6 pcs)
#81
. M5 x 12mm
Phillips Head Screw
(4 pcs)
#90
. 5/16” x 1-1/4”
Hex Head Bolt (4 pcs)
#95
. 5/16” x 3/4” Button
Head Socket Bolt
(6 pcs)
#96
. 3/8” x 3-1/2”
Carriage Bolt (2 pcs)
#97
. 3/8” x 23mm
Curved Washer (2 pcs)
#98
. 3/8”
Cap Nut (2 pcs)
#99
. M6 x 15mm
Phillips Head Screw
(4 pcs)