XtendLan DPC-536, Руководство по программированию и отладке

Страница: 7 / 21

7
4.4.2 Monitor Programming Procedure
Make sure before program:
The Door Station is under
Monitor Program state.
The Monitor is connected
correctly and is powered on.
Step 1:
Press “ CALL ” button on the
Monitor to be programmed
Step 2:
The previous Room Code is
showed, with hints in bottom line
to input new Room Code, at the
same time, lapse counter starts
Step 3:
Input new Room code in
4-digits format; then Press
“#” to start programming.
The result will be displayed
after 2~4s normally
Important Notes:
- Please note when Door Station runs in Monitor Program state, the rest functions of system are blocked
temporarily.
- Valid program timing is limited in 10 seconds, after pressing the Monitor’s CALL Button. If exceeding the
timing limitation, Door Station will clear the inputs and returns to Monitor Program menu.
- It is critical to make sure that only the Monitor to be programmed can be operated during programming.
- If repeated Room Code is checked, programming will fail and display “Overlap” information.
- You can program all Monitors before installation, and then make installation according to the Room Code.