XS Scuba Inspire Octopus, Руководство по обслуживанию

Страница: 35 / 38

35
www.XSscuba.com
XS Scuba Inspire Regulator Service Manual
S
ymptom
p
oSSible
C
auSe
S
olution
Pressure Creep (Drift)
MP doesn’t stabilize or
MP continues to climb more
than 5psi in 5 min
1. There is a problem with the
HP seat (22) / crown orifice interface
2. There is a problem with the HP o-ring (24)
1. Try replacing the HP Seat (22) first.
2. Try replacing the HP o-ring (24).
3.
The crown orifice in the main body (11)
may be compromised. Replace the main
body (11).
MP is stable but too low
Main spring force is too weak Turn the adjustment screw (19) CW.
MP is stable but too high
Main spring force is too strong Turn the adjustment screw (19) CCW.
Restricted Air Flow
Hard inhalation throughout
entire system
Cylinder valve not opened all the way Open valve all the way. Check supply pressure
Cylinder valve requires service Get valve serviced
Conical filter is wholly or partially
contaminated
Service entire regulator including filter
replacement
Visually inspect cylinders being used
MP is too low See solution above
External Air Leakage (found
during immersion test))
Turret bolt Replace o-ring (27)
HP plug Replace o-ring (29)
MP plug Replace o-ring (31)
Yoke/DIN connector Replace o-ring (8)
Diaphragm clamp
Replace diaphragm (13) and diaphragm
washer (14)
Swivel turret Replace o-ring (20)
First Stage Troubleshooting Guide