XS Scuba Inspire Octopus, Руководство по обслуживанию

Страница: 31 / 38

31
www.XSscuba.com
XS Scuba Inspire Regulator Service Manual
NOTE: As you apply torque to the locking nut
(8) on the valve housing (17), inspect the two lever
arms in relation to the rim of the main housing (1).
If the torque on the nut causes the valve housing
to rotate in the main housing thus causing the lever
arms to tilt to one side, use the wrench to turn the
nut ever so slightly CCW to level out the two lever
arms. See diagram.
7. Install the Crown Orifice
A. Press the crown orifice, narrow end in first, into
the narrow end of the valve housing
B. Using the Regulator In-Line Adjusting Tool,
TL121, or a 3/16” hex key, press the crown orifice
in as far as it will travel. Turn it CW two complete
revolutions. This is the preset position.
Center Line
Top Edge of Lever Arm
8. Adjusting Lever Height
A. Thread the TL121 Tool onto the air inlet end of the
valve housing
B. Connect a medium pressure hose (135 to 145 psi)
to the inlet side of the TL121 tool
C. Pressurize the valve
D. Engage the TL121 drive bit with the crown orifice.
While watching the lever, observe that turning the
crown orifice in CW will lower the lever, while turning
it out, CCW, raises the lever. Adjust the crown orifice
so that the lever reaches its maximum height.
7A
7B
8A
8D