Xray t1m, Инструкция по эксплуатации

Страница: 19 / 24

18
8. FRONT FINAL ASSEMBLY
309333
301229
309345
309345
309344
301217
309393
301200
308300
309452
301320
1 1..
Place a #309393 (N M3) nut into the hex recess atop the #301200
lower bumper.
2 2.. Place the lower bumper onto the front of the chassis.
3 3..
Thread a #309344 (SFH M3x8) screw up through the bottom of the
chassis, through the bumper, and into the M3 nut.
4 4..
Thread two #309345 (SFH M3x10) screws up through the bottom of the
chassis and into the lower bumper.
30 1200 COMPOSITE BUMPER
30 1217 COMPOSITE UPPER BUMPER SUPPORT
30 1320 FRONT BODY MOUNTS ( SET )
30 9333 HEX SCREW SH M3x6 (10)
30 9344 HEX SCREW SFH M3x8 (10)
30 9345 HEX SCREW SFH M3x10 (10)
30 9393 NUT M3 (10)
30 9452 PIN 2x10 (10)
30 1229 1/12 FOAM BUMPER
30 8300 XRAY SHOCK ABSORBER-SET 4-STEP (2)
➊
➋
BAG
08
309344
SFH M3x8
309345
SFH M3x10
309345
SFH M3x10
309393
N M3
Attach TWO front shocks by performing the following steps.
1 1..
Attach the top of the front shock to the front shock tower.
Mount the top pivot ball of the assembled rear shocks to the graphite shock
tower using #309333 (SH M3x6) screws. Thread into the indicated hole in the
rear shock tower.
2 2..
Attach the bottom of the front shock to the front lower arm.
Mount the lower pivot ball of the assembled rear shocks to the exposed
screws on the lower suspension arms.
➊
➋
➌
➍
➎
➑
➐
1 1.. Insert the front body posts into the holes
of the #301217 upper bumper support.
2 2..
Slide the #301229 foam bumper up onto the body posts;
the posts should extend down through the foam bumper.
3 3.. Position the bumper assembly onto the lower bumper.
4 4..
Secure the body posts to the lower bumper
by threading two #309345 (SFH M3x10) screws
upward through lower bumper into the bodyposts.
5 5.. Secure the upper bumper support to the front
bulkheads with two #309333 (SH M3x6) screws.
6 6..
Glue rubber washers to the tops of the plastic body supports.
7 7.. Insert a #309452 (P 2x10) pin into a hole in a front body post.
Insert the other pin into the same hole in the other body post.
8 8..
Slide the body supports into the body posts, and snap onto the pins.
CA GLUE
➏
➊
➋
➌
➍
➍
309333
SH M3x6
309333
SH M3x6
309452
P 2x10
FRONT SHOCK TOWER FRONT LOWER ARM
INITIAL POSITION