10
LON
GER
SHO
RTER
309343
SFH M3x6
Identify the nylon holders used to mount the front lower arms
to the front bulkheads; they are marked for easy
identification. Also identify the holes in the front bulkheads
where you will mount the lower arms.
1
1..
Mount lower suspension holders
and
to the
inside rear of the bulkheads, using #309336 (SH M3x12)
screws. The holes in the holders point toward the front.
2
2..
Slide a #307214 pivot pin through the holes
in the two front lower arms. Position the front
suspension arm in the front bulkhead.
3
3..
Insert the lower suspension holders
and
to
the pins on the right and left arms, respectively. Mount the
holders to the bulkheads using #309336 (SH M3x12)
screws. Use the middle hole in each front bulkhead as
shown.
309336
SH M3x12
Use front MIDDLE hole
LLoow
weerr FFrroonntt SSuussppeennssiioonn H
Hoollddeerrss
Right rear: Holder 3
Left front: Holder 3
Right front: Holder 2
Left rear: Holder 2
FRONT TRANSMISSION
309358
SB M4x8
309354
SB M3x8
1
1..
Mount the right front bulkhead to the
lower chassis using three #309343
(SFH M3x6) screws.
2
2..
Place remaining differential inside
the front end of the long drive belt.
Make sure the differential is oriented so
the shorter diff output shaft is near the
right front bulkhead.
3
3..
Insert the shorter output shaft of the
differential into the ball-bearing in the
right front bulkhead.
4
4..
Slide the left front bulkhead into
position over the other end of the
differential, and mount to the lower
chassis using three #309343
(SFH M3x6) screws.
➊
➊
➋
➌
➌
➋
➊
➋
➌
➍
B
OTTOM
T
OP
F
RONT
F
RONT
➊
➌
F
RONT
➊
➌
2.5 mm
➊
➊
➋
➋
2.0 mm
The left and right front lower arms are mirror images.
1
1..
Thread a #309358 (SB M4x8) downstop adjustment screw into the hole at the rear of
each front lower arm. The screws must protrude 2.0 mm below the arms, and must be
accessible from the tops of the arms for adjustment.
2
2..
Thread #309354 (SB M3x8) shock mounting screw into
the hole located on the outside of the arm, as shown.
It must protrude 2.5 mm.
