Xray t1m, Инструкция по эксплуатации

Страница: 18 / 24

17
309344
308300
309334
301330
309452
301230
309333
309393
Attach TWO rear shocks by performing
the following steps.
1 1.. Attach the top of the rear shock to the rear shock tower.
Mount the top pivot ball of the assembled rear shocks to the
graphite shock tower using #309335 (SH M3x10) screws.
Thread into the indicated hole in the rear shock tower.
2 2.. Attach the bottom of the rear shock to the rear lower arm.
Mount the lower pivot ball of the assembled rear shocks to
the exposed screws on the lower suspension arms.
3 3..
Place the #301230 rear bumper over the rear of the
chassis. Place a #309393 (M3) nut into the hex recess atop
the bumper. Thread a #309344 (SFH M3x8) screw up
through the bottom of the chassis and through the bumper
into the nut.
30 1230 COMPOSITE BUMPER REAR
30 1330 REAR BODY MOUNT SET
30 9334 HEX SCREW SH M3x8 (10)
30 9333 HEX SCREW SH M3x6 (10)
30 9344 HEX SCREW SFH M3x8 (10)
30 9393 NUT M3 (10)
30 9452 PIN 2x10 (10)
30 8300 XRAY SHOCK ABSORBER-SET 4-STEP (2)
Assemble TWO rear body posts by performing the following steps.
1 1..
Mount the body post to the front of the rear shock tower. The bottom
plastic pin fits into the lower hole. Use a #309334 (SH M3x18) screw to
fasten each body post to the shock tower.
2 2..
Insert a #309452 (P 2x10) pin into one of the holes in a rear body post.
Insert the other pin into the same hole in the other body post.
3 3.. Glue a rubber washer to the top of a plastic body support.
4 4..
Slide the body support onto the body post, and snap onto the pin.
8. REAR FINAL ASSEMBLY
BAG
08
309334
SH M3x8
309452
P 2x10
CA GLUE
➊
➋
➊
➋
➌
➍
REAR LOWER ARM
REAR SHOCK TOWER
309393
N M3
309344
SFH M3x8
309333
SH M3x6
INITIAL POSITION
➌