Xinje VB3-20P7, Руководство пользователя

Страница: 89 / 107

V5 series inverter
83
command is input.
Fig. Fig. Fig. Fig. 4-42 4-42 4-42 4-42 PLC PLC PLC PLC holding holding holding holding mode mode mode mode after after after after single single single single cycle cycle cycle cycle
Fig.
Fig. Fig.
Fig. 4-43
4-43 4-43
4-43 PLC
PLC PLC
PLC operate
operate operate
operate conti
conti conti
continuously
nuously nuously
nuously mode
mode mode
mode
3 3 3 3:::: Operate Operate Operate Operate continuously continuously continuously continuously.... As in Fig.4-43
，
inverter start next cycle automatically after operating for one cycle, it will stop
until stop command is input.
Ten Ten Ten Ten’’’’ssss place: place: place: place:
Restarting mode after stopping
0
：
Run again for stage 1
1
：
Continue to run from the stopping stage
Hundred Hundred Hundred Hundred’’’’ssss place place place place
：
Save at power off
0
：
Not saving
1
：
Save the time and frequency at power off
Thousand Thousand Thousand Thousand’’’’ssss place place place place : Selecting the unit of time
0: second
1: minute
Ten Ten Ten Ten’’’’ssss place place place place of of of of LED LED LED LED
：
PLC restarting mode after stopping
0 0 0 0:::: Run again from stage 1 .... Inverter will start to run from stage 1 if the stop is caused by stop command, fault or power off.
1 1 1 1:::: Continue to run from the stopping stage .... For the stop caused by stop command or fault, inverter will recorc the time in
current phase automatically, then restart to enter this stage with the same frequency and run continuously in the rest time, as
shown in Fig.4-44.