Xinje VB3-20P7, Руководство пользователя

Страница: 38 / 107

V5 series inverter
32
Fig. Fig. Fig. Fig. 3 3 3 3
－
4 4 4 4 Display Display Display Display during during during during initialize, initialize, initialize, initialize, STOP STOP STOP STOP and and and and RUN RUN RUN RUN
2 2 2 2.... Parameters Parameters Parameters Parameters displayed displayed displayed displayed in in in in running running running running status status status status
When the inverter receive the running command, it starts to enter running status and operation panel will display running
monitor parameters, the default parameter is output frequency (b-00 monitor parameter),as shown in Fig.3-4-B, the unit
indicator on the top right indicates the unit of this parameter
Press key can display parameter in running status circularly (defined by function code P3.41 and P3.42).While
displaying, press jkjk key to shift to the default parameter b-00
，
that is output frequency
，
Otherwise, the operation panel
will display the last monitor parameter constantly.
3 3 3 3.... Alarm Alarm Alarm Alarm information information information information
When then inverter detects a fault signal, the panel will display fault code, the code will flash to catch your attention as
shown in Fig.3-5; Press key to view the relative fault parameters in stopping status, and then press to shift to
fault code display.
If you want to view fault information, press to view P6 parameter in editing status.After you finding out and solve
the default, the inverter can be reset by key in operation panel or control terminals or communication command. The
fault code will not disappear until the fault is cleared.
Note
Note Note
Note
：
For some serious default such as over current, over voltage etc. please do not reset the inverter to rerun before
confirming that the default is cleared, otherwise the inverter may be damaged.
Fig.
Fig. Fig.
Fig.3
3 3
3
—
5
5 5
5 Alarming
Alarming Alarming
Alarming display
display display
display status
status status
status
4 4 4 4.... Editing Editing Editing Editing status status status status
This status can be entered by pressing key in stopping ,running or fault alarming status(if there is a user’s password,
you should input correct password, refer to P0.00 and Fig 3-9 for details).This status can be displayed in three level menu,
they are: code gruop
→
code No.
→
code parameter, you can enter the sub-menu by pressing .In code parameter status,
press to save parameter and press to exit without saving.
Fig.A Fig. B Fig. C
Power on and
initialize, display
the dynamic picture Stop status, display
the stop parameters running status,
display the running
parameters