Xilinx EH600 A Series, Руководство пользователя

Страница: 21 / 92

18
X1-CM
AI1-GND
AI2-GND
X2-CM
X3-CM
X4-CM
X5-CM
X6-CM
FWD-CM
REV-CM
RST-CM
Output function selected by parameter F4.01 and F4.02
Output function selected by parameter F4.00
Output voltage range 0 10V ： ～
Output current range 0 20mA ： ～
Output voltage range 0 10V ： ～
Output pulse range 0 50kHz ： ～
24V-CM
Normally close terminal
Normally open terminal
Type Terminal Terminal name Function description
10V-GND
Contact driving capability : resistive load Contact rating : AC 250V 1A
DI-GND
AO1-GND
AO2-GND
OC1
OC2
TA-TB
TA-TC
TA TC X2 X5
X6
FWD REV
OC2 DI
GND
GND
AI2
AO1
AO2
TB X1 X3
X4
CM CM
CM 24V RST
OC1
10V AI1
Chapter 3 Mechanical and Electrical Installation
over current protection of the inverter .When the length of motor cable is longer than 30m , it needs to reduce carrier wave so
so that to decrease leakage current .When the length of motor cable is longer than 50m, it needs to install AC output reactor .
resistance less than 5 . Otherwise , it maybe cause fault or damage the inverter . Do not share the earth terminal and zero Ω
line of the power supply .
D Earth terminal E : The terminal should be earthed reliably , the diameter of earth cable should be more than 10mm , with
、 2
5、Control terminals and connection :
1) The control circuit terminals are arranged as follows :
2) Function description of control terminal :
Power
supply
Analog
input
Analog
output
Analog output 1
Analog output 2
OC
output
Relay
output
Digital
input
Control
terminal
Analog input
terminal 2
Analog input terminal 1
Multi-functional input
terminal 1
Multi-functional input
terminal 2
Multi-functional input
terminal 3
Multi-functional input
terminal 4
Multi-functional input
terminal 5
Multi-functional input
terminal 6
High-speed
pulse output
Input voltage range : DC 0V 10V
～
Input voltage range : DC 0V 10V Input current range : DC 0 20mA ～ ～
Input voltage range : DC 5V 24V ～
The maximum input frequency : 50kHz
Specific function of the Multi-function digital input terminals are set by
parameter F3.00 F3.05 ～
The terminals work when close to CM terminal .
The terminals work when close to CM terminal .
The voltage or current output is determined by the AO1 jumping wiring
on the control board .
The voltage or high-speed pulse output is determined by the AO2 jumping
wiring on the control board .
It is determined by AI2 jumping wire . It is 500 at the time of current input .
Ω
External 10V
power supply
P10V power supply for external-units , and the maximum output
current is 10mA. It is generally used as the operating power supply for the
external potentiometer . The potentiometer resistance range is 1k 5k . Ω～ Ω
P24V power supply for external units . It is generally used as the
operating power supply for digital input/output terminals and the external
sensor . The maximum output current is 50mA .
External 24V
power supply
Open collector output 1
Open collector output 2
Positive rotation
control terminal
Reverse rotation
control terminal
Fault reset
input terminal