-6-
Default /start screen
This screen (
Picture 13
) allows selection of the main screen
at power-up. There is a delay of few seconds after power-
up before changing to selected screen.
Stall Alarm
(Only available if Pitot or GPS installed)
The Airspeed information when is transmitted by telemetry,
some radios allow to set voice alarms to indicate the
airspeed, especially during landing. For those radios without
telemetry, or in slow telemetry systems, an optical aid can be
controlled by the Flight Computer. Through the LED
connector the system can power two high power LEDs
(250mA maximum) to be installed in the airframe. The leds
will light accordingly to airspeed per the settings entered in
this screen. Pilot can get the information of the speed quickly
and without taking the focus away from the plane.
Speed information is taken from Pitot tube in “Plus” models.
In “Basic” models, the GPS module should be installed to enable this function.
Warning:
The speed measured by the GPS module is related to ground, it does not account for
the wind. Alarms could be unreliable in windy conditions using GPS data.
Telemetry output
All the information from the engine and different sensors is
sent to the receiver through the “Tele Out” port when used
together in Jeti, Multiplex, HoTT and Futaba radios.
Spektrum radios will be supported using the central white
connector.
Main telemetry setup allows selection of the radio brand
(
Picture 15
) and to enter the tank capacity and pump factor
(please check the manual of the Xicoy telemetry adapter for
detailed description).
To change any setting, first touch the “Edit” button to enable the fields to be modified. Once
information is entered, click the “Save” button to store the settings in permanent memory.
Picture 13
Picture 14
Picture 15
