Reset to Default Parameters
Press and hold all three buttons ( + + ) simultaneously until the screen is off.
Release the buttons and the controller will auto-restart after reset to default parameters.
9
Please power on the controller before reset.
If the following conditions occur, the buzzer will beep and error code will show on the LCD to
alert. Press any button can mute the buzzer but error code will remain until the problems solved.
●
When LCD screen displays error code
“Err”
:
The probe may be disconnected or not installed correctly. Please try to re-install the probe.
If the
“Err”
code remains on the screen, please replace with a new one ASAP.
●
When LCD screen displays error code
“EAH”
:
The controller is in high temperature alarm status as current temperature is above high alarm
limit (PV ≥ AH). Please check and solve it ASAP to avoid any damage or loss.
●
When LCD screen displays error code
“EAL”
:
The controller is in low temperature alarm status as current temperature is below the low
alarm limit (PV ≤ AL). Please check and solve it ASAP to avoid any damage or loss.
6.0 Error Code
7.0 Reset
8.0 Specifications
Power supply:
100~250VAC, 50/60Hz
Total power consumption:
<5W
Temperature measuring range:
-45°C ~115°C/-49°F~239°F
Temperature control range:
-40°C~110°C/-40°F~230°F
Temperature resolution:
0.1°C/0.1°F
Temperature accuracy:
±1°C/±2°F
Operating ambient temperature:
-10°C~65°C/14°F~149°F
Storage temperature:
-20°C~75°C/-4°F~167°F
Relay contact output rating:
10A res. @ 100 ~ 250VAC
Maximum Power:
1100W @ 110V/2200 W @ 220V
Probe type:
NTC (10KΩ/25°C, B value = 3435K)
Cable length (Probe):
2m
Cable length (Power plug):
1.5m
Cable length (Heating/Cooling Outlet):
0.3m
Dimensions:
165 x 60 x 32 mm
Best LCD screen viewpoint:
6 o'clock position
