Xerox WorkCentre PE120i, Руководство системного администратора

Страница: 39 / 131

Xerox WorkCentre PE120i System Administration Guide Page 3-5
Ne
tW
a
re
Using NetWare Utilities
Installation Procedure
There are three stages required to install the WorkCentre PE120i on a NetWare network using
NetWare utilities:
¾
Network Communication Setup
This procedure will enable the WorkCentre PE120i to communicate on the
NetWare network.
¾
NetWare Setup
This procedure is used to setup the network using NetWare utilities, for
example NWADMIN.
¾
Test Print
A print job should be submitted to ensure the WorkCentre PE120i has been
installed and configured correctly.
If running NLSP, ensure that RIP/SAP compatibility is configured on the same segment as the
WorkCentre PE120i .
Network Communication Setup
At the WorkCentre PE120i , perform these steps:
HINT: Xerox CentreWare Internet Services can also be used to configure the
WorkCentre PE120i, refer to the Internet Services chapter for instructions.
¾
Ensure that the Basic TCP/IP settings have been configured (see “Network
Communication Setup” on page 2-5 ).
1
2
¾
Press [Menu] until you see
Network Setup on the top line of
the display.
8. Network Setup
[Reset Network]