Xerox WorkCentre PE120i, Руководство системного администратора

Страница: 27 / 131

Xerox WorkCentre PE120i System Administration Guide Page 2-3
B
a
sic
N
e
tw
o
rk I
n
st
al
la
ti
on
Basic TCP/IP Settings
Before the printer can be used on the network, the TCP/IP addresses need to be entered.
These can be entered automatically using Dynamic Host Configuration Protocol (DHCP) or
Bootstrap Protocol (BOOTP) or entered manually. To enter the addresses manually, you need
to obtain the following:
¾
TCP/IP Address
¾
Gateway Address
¾
Subnet Mask Address
¾
Primary DNS Server Address
Installation Procedure
There are three stages required to install the WorkCentre PE120i in a TCP/IP networking
environment:
¾
Network Communication Setup
This requires the WorkCentre PE120i to be setup for TCP/IP.
¾
Workstation Setup
This requires the Workstations in the networking environment to be
configured to communicate with the
WorkCentre PE120i .
¾
Test Print
A print job should be submitted to ensure the WorkCentre PE120i has been
installed and configured correctly.