WorkCentre 7655/7665 Tab Creation Supplement
Page 5 of 22
2. Setup
This chapter describes how to load tab stock into the paper
tray and how to create tab masters.
Loading Tab Stock Into The Paper Trays
This procedure is the same for both copying and printing
onto tab stock.
NOTE
Tab stock can only be loaded into Bypass Tray. The stock
you are using for the body of the document should be loaded
into any tray. Use 8.5 x 11 inch paper with 9 x 11 inch tab
stock or A4 paper with A4 tab stock in the same orientation.
Bypass Tray
1. Load the Single Straight Collated tab stock into the
bypass tray as follows:
a) Tabs to the left with tab 1 on top and at the front of
the tray.
b) Tabs in standard order. If more than one set of tabs
is required, the number and sequence of the tabs
loaded must match the number and sequence of
tabs to be printed. Any surplus tabs should be
removed from each set prior to starting the job.
c) If you have to reload tabs in case of jam or for any
reason, please make sure tab 1 is on top and at
front of the tray.
2. Move the rear guide against the rear edge of the tab
stock.
