![background image](http://html1.mh-extra.com/html/xerox/phaser6700/phaser6700_system-administrator-manual_4224868034.webp)
Network Configuration
34
Phaser 6700 Color Printer
System Administrator Guide
Raw TCP/IP Printing
Raw TCP/IP is used to open a TCP socket-level connection over Port 9100, and stream a print-ready file to
the printer input buffer. It then closes the connection either after sensing an End Of Job character in the
PDL or after expiration of a preset timeout value. Port 9100 does not require an LPR request from the
computer or the use of an LPD running on the printer. Raw TCP/IP printing is selected in Windows as the
Standard TCP/IP port.
Configuring Raw TCP/IP Settings
1.
In CentreWare Internet Services, click
Properties
>
Connectivity
>
Protocols
.
2.
Click
Raw TCP/IP Printing
.
3.
Select
Enabled
to enable the protocol.
4.
Ensure that the TCP Port Number is set to
9100
for Port 1. If you want to emulate HP JetDirect EX
Plus 3, set Port 2 to
9101
and Port 3 to
9102
.
5.
Select
Enabled
for bidirectional communication.
6.
Set the Maximum Connections per port between
1–32
for each port. The default port value is 32.
7.
Set the End of Job Timeout to the desired number of seconds between
0–1800
before the job is
processed with an End of Job character. The default time is 300 seconds.
8.
Select
Enabled
for PDL Switching to allow the printer to switch automatically between multiple
supported PDLs within a single job. PDL switching is normally disabled.
9.
Click
Apply
to save the new settings or
Undo
to retain the previous settings.
Click
Default All
to reset settings to default values.
Note:
Enable TCP/IP before enabling Raw TCP/IP printing.
Configuring Raw TCP/IP Advanced Settings
Use this page to set additional Raw TCP/IP Printing options for Ports 1, 2, and 3.
To configure Advanced Settings:
1.
Under Connections, set the following:
Set the Maximum Connections per port between
1–32
. The default port value is 32.
To allow concurrent jobs to process for each port connection, type a number between
0–500
jobs in each port. Type
0
to allow unlimited concurrent jobs.
To limit the number of jobs that are active for each port connection, type a number between
0–32768
. Type
0
to allow unlimited number of active jobs.
2.
Under Job Boundary Determination:
Type the End of Job Timeout between
0–1800
seconds to specify the amount of time to pass
before a job processes with an End of Job character. The default time is 300 seconds. Type
0
to
disable end of job detection by timeout.