Description of Menu Items
Phaser® 6125 Color Laser Printer
5-7
Network Setup
Specifies printer settings affecting jobs sent to the printer through a network port.
■
The settings in the Network Setup menu cannot be set when entering this menu during
printing.
■
You need to restart the printer to activate the new settings. After making the settings, turn
off the printer and then turn it on again.
Item
Description
Ethernet
Specifies the communication speed and the modes of Ethernet.
■
Auto (default)
Automatically changes between 10M Half Duplex, 10M Full Duplex, 100M
Half Duplex, and 100M Full Duplex.
■
10M Half Duplex
■
10M Full Duplex
■
100M Half Duplex
■
100M Full Duplex
TCP/IP
Specifies the settings to use the TCP/IP protocol.
Get IP Address
Specifies whether to automatically or manually retrieve the IP address.
■
DHCP/Autonet
(default)
Automatically sets the IP address.
■
BOOTP
Uses BOOTP to set the IP address automatically.
■
RARP
Uses RARP to set the IP address automatically.
■
DHCP
Uses DHCP to set the IP address automatically.
■
Panel
You can set the IP address manually by entering it on the operator panel.
IP Address,
Network Mask,
Gateway
Address
These items are used to check the addresses that have been obtained
automatically or to specify addresses manually. Enter the address in the format
of xxx.xxx.xxx.xxx. You can specifies values in the range of 0 to 255 for xxx.
■
To set addresses manually, set the
Get IP Address
to
Panel
.
■
IP addresses are managed in the entire network. An incorrect IP address
may affect the whole network. For the addresses you need to set manually,
contact your network administrator.
Protocol
Set
Enable
when using the protocol. When
Disable
is selected, the protocol
cannot be activated.
■
LPR
(default: Enable)
■
Port 9100
(default: Enable)
■
FTP
(default: Enable)
■
SNMP
(default: Enable)
■
Email Alerts
(default: Enable)
■
CentreWare IS
(default: Enable)