
Media and tray
_ 36
•
Do not print on media smaller than 76 mm (3.00 inches) wide or 127 mm
(5.00 inches) long.
•
In the software application, set margins at least 6.4 mm (0.25 inches)
away from the edges of the material.
•
If media weight is over 160 g/m
2
(43 lb), try printing in the rear cover
(face up).
Letterhead/ Preprinted paper
•
Letterhead/ Preprinted paper must be printed with heat-resistant
ink that will not melt, vaporize, or release hazardous emissions
when subjected to the machine’s fusing temperature (about
170°C(338 °F) for 0.1 second.
•
Letterhead/ Preprinted paper ink must be non-flammable and
should not adversely affect machine rollers.
•
Forms and letterhead should be sealed in a moisture-proof
wrapping to prevent changes during storage.
•
Before you load letterhead/preprinted paper, verify that the ink on
the paper is dry. During the fusing process, wet ink can come off
preprinted paper, reducing print quality.
Photo
•
Make sure not to use the inkjet photo paper with this machine. It could
cause damage to the machine.
Glossy
•
Load one paper to the manual tray at a time, glossy side facing up.
USING THE OUTPUT SUPPORT
The surface of the output tray may become hot if you print a large
number of pages at once. Make sure that you do not touch the
surface, and do not allow children near it.
The printed pages stack on the output support, and the output support will
help the printed pages to align. The printer sends output to the output tray
by default. To use the output tray, make sure that the rear cover is closed.
SINGLE-SIDED
DOUBLE-SIDED
Tray1
Face down
Face up
Manual tray
Face up
Face down
Содержание Phaser 3160B
Страница 1: ......
Страница 6: ...table of contents Table of contents_ 6 GLOSSARY 67 ...
Страница 71: ...Glossary_ 71 ...