Xerox Legacy 4112, Руководство системного администратора

Страница: 40 / 364

Xerox 4112/4127 Copier/Printer System Administration Guide 2-2
2. Configuration
Configuration on the machine (LPD)
This section describes the configuration procedure to use TCP/IP
(LPD/Port 9100) protocol on the machine. First enable the LPD
Port or Port 9100 port, then assign the IP address.
NOTE 1: The configuration can also be performed using
CentreWare Internet Services or CentreWare Utilities.
NOTE 2: Enable the SOAP port and the SNMP port in most cases.
Refer to
“Using CentreWare Internet Services” on page 3-1
.
1. Enter the System Administrator Mode (Chapter 1 Entering the
System Administrator Mode on page 1-15
.
)
2.
Enable either the LPD port or the Port 9100 port as
appropriate. In this example, the LPD port is enabled.
a. Select
System Settings
.
b. Select
Connectivity & Network Setup
.
c. Select
Port Settings
.
d. Select
LPD
and then select
Change Settings
.
e. Select
LPD - Port Status
and select
Change Settings
.
f. Select
Enabled
and then select
Save
.
g. Select
Close
repeatedly until the
Connectivity & Network
Setup
screen is displayed
3.
If necessary, set the IP Address (Chapter 1 Setting the IP
address. on page 1-17).
4.
Exit the System Administrator Mode (Chapter 1 Exiting the
System Administrator Mode on page 1-16).
5.
After the machine is restarted, print out the
Printer Settings
List
to confirm that the LPD port is enabled.
Configure the LPD as necessary. Refer to
“LPD” on page 3-13
for
the LPD configuration. Also if using Port 9100, configure as
necessary. Refer to
“Port 9100” on page 3-18
for the Port 9100
configuration.