Xerox CiPress 325, Руководство по многопоточности в вебе

Страница: 51 / 60

21. Open the Infeed Module Front Door of the Primary CiPress™. Using a ruler or rigid
measuring tape, measure the distance in millimeters between the Infeed Module
Front Frame Plate and the beginning edge of the web.
Location to measure.
1
Ruler measuring distance. 2
22. Choose from the following options depending on where the web edge is located
compared to the distance calculated in the previous section.
• If the measurement you take is /- 3 mm when compared to the distance
calculated earlier, the web registration is acceptable. Close the Infeed Module
Front Door. Continue to the next step.
• If the measurement you take is o/- 3mm when compared to the distance
calculated earlier, release the Infeed Module and Outfeed Module Nip levers and
go back to the beginning of
Web Registration Procedures .
23. Open the Left and Right Marking Tower Front Doors of the Primary CiPress™ and
replace the drip trays at both sides.
24. Open the Infeed Module Front Door and Side Door.
25. Lock the Infeed Module Release Nip lever.
26. Ensure a gap of 5 mm (0.2 in) between the Front and Rear Web Guides and the edges
of the web exists.
9-5
Xerox
®
CiPress™ 325 / 500 Production Inkjet System
Web Threading Guide
Setting Up and Activating the Web Registration Module