Xenotech BL7000, Руководство по эксплуатации

Страница: 10 / 38

PAGE 10
NOTE
ANY TYPE OF ALCOHOL IS SUITABLE FOR CLEANING THE BULB EXCEPT FOR ALCOHOL THAT HAS
BEEN DENATURED USING PETROLEUM PRODUCTS. THE DENATURING AGENT WILL LEAVE A
RESIDUE ON THE BULB.
12. Remove the protective cover from the globe and clean the quartz portion of the bulb completely with alcohol.
13. Reinstall the front cowl using the screws that were removed during disassembly.
14. Log the hour meter reading at installation.
15. Test the lamp operation and preform the output power adjustment procedure.
CAUTION
LAMP COOLING
DO NOT DISCONNECT THE MAIN POWER UNTIL THE BULB HAS COMPLETELY COOLED. THE LAMP
HEAD COOLING SYSTEM WILL RUN WHENEVER THE MAIN INPUT POWER LINES ARE ENERGIZED.
NOTE
LAMP HEAD TEMPERATURE AND COOLING SYSTEM PROTECTION CIRCUIT
THE LAMP HEAD AND POWER SUPPLY ARE THERMALLY PROTECTED. THE LAMP HEAD IS ALSO
PROTECTED BY AN AIR PRESSURE SWITCH . IF THE LAMP HEAD COOLING SYSTEM FAILS OR THE
EQUIPMENT IS USED IN AN EXCESSIVELY HOT ENVIRONMENT ( ABOVE 50
DEG C ) THE LAMP POWER
SYSTEM WILL SHUT OFF TO PREVENT EQUIPMENT DAMAGE AND THE HEAD OVER TEMP / SAFETY
CIRCUIT FAULT INDICATOR (8) WILL LIGHT. WHEN THE EQUIPMENT COOLS TO A SAFE OPERATING
TEMPERATURE OR WHEN THE FAULT IS CLEARED THE INDICATOR WILL GO OUT, THE MAIN POWER
CONTACTOR IN THE POWER SUPPLY WILL REENERGIZE, AND THE LAMP MAY THEN BE RELIT.
NOTE
ARC MAGNETIC STABILIZATION
THE LAMP HEAD INCORPORATES MAGNETIC STABILIZATION OF THE GLOBE ARC. THE LAMP HEAD
MUST BE OPERATED IN AN UPRIGHT POSITION FOR THE STABILIZATION TO WORK PROPERLY. THE
POSITION OF THE LAMP HEAD CAN BE DETERMINED BY THE POSITION OF THE TEXT ON THE SIDES
OF THE LAMP HEAD WHICH SHOULD BE UPRIGHT. OPERATING THE LAMP HEAD UPSIDEDOWN MAY
CAUSE MASSIVE INSTABILITY IN THE GLOBE ARC TO THE POINT OF EXTINGUISHING AND MAY
CAUSE EXCESSIVE LAMP WEAR.
CAUTION
SHOCK HAZARD
THE POWER SUPPLY CONTAINS A CAPACITOR BANK ACROSS THE OUTPUT TERMINALS THE ENERGY
STORED IN THE CAPACITORS MAY BE PRESENT FOR SEVERAL MINUTES AFTER THE POWER SUPPLY
IS DE-ENERGIZED.
CAUTION
SHOCK HAZARD
DISCONNECT THE INPUT POWER CONNECTOR BEFORE SERVICING THIS EQUIPMENT. DANGEROUS
VOLTAGES ARE PRESENT IN THIS EQUIPMENT.