Xenotech BL7000, Руководство по эксплуатации

Страница: 11 / 38

PAGE 11
REMOVING A "FROZEN" XENON BULB
1. Replace the front lamp holder retaining bolt to support the front of the bulb while freeing the bulb from the rear
lamp holder.
2. Remove the fixture rear cover by removing the (10) screws around the perimeter of the sides using a #2
phillips screwdriver and pulling the cover straight back using the rear handle.
3. Disconnect the rear panel wiring connectors from the head wiring harness then set the cover aside.
4. Remove the plenum access cover by removing the (10) screws from around the cover using a #2 phillips
screwdriver and remove the cover.
WARNING
DO EXERT ANY FORCE ON THE QUARTZ PORTIONS OF THE BULB WHILE ATTEMPTING TO FREE IT
FROM THE REAR LAMP HOLDER!
5. Reach around the rear lamp holder assembly and grasp the bulb by its rear ferrule and while lightly pulling the
bulb back into the receiver block; turn the bulb in a clockwise direction until the bulb begins to rotate freely.
6. Once the bulb is free, do not remove it completely from the rear lamp holder.
7. Replace the plenum cover, rear panel wiring, and fixture rear cover.
8. Return to step 5 of :
“DISASSEMBLY PROCEDURE
IF THERE IS A XENON BULB INSTALLED IN THE FIXTURE”