DO NOT RETURN TO RETAILER WHERE YOU PURCHASED AT.
CONTACT XDP FOR PARTS AND SUPPORT AT 1.866.884.0535 or [email protected]
16
ASSEMBLY INSTRUCTIONS
Place the playground equipment on level ground
and not less than
6ft (1.8m) from any structure or obstruction such as a fence, garage,
house, overhanging branches, laundry line or electrical wires.
Do not install the playground equipment over concrete, asphalt,
packed earth or any other hard surface; a fall onto a hard surface can
result in serious injury or death to the equipment user.
Adequate overhead clearance is essential. A minimum clearance
from ground level shall be recommended. Provide clearance for
wires, tree limbs and other possible hazards.
Use the swing set in a well-lighted area. Artificial illumination may be
required for shady areas.
Secure the swing set against unauthorized and unsupervised use.
The owner and supervisors of the swing set are responsible to make
all users aware of practices specified in the use instructions.
TIGHTENING NUTS & BOLTS
For ease of installation, do not over-tighten the nuts and bolts when
you are first putting the equipment together. This will allow for
some possible adjustments during installation.
Once you have finished assembling each component of the play set,
make sure to go back over each step and properly tighten all nuts,
bolts and plastic caps.
Check the entire unit to ensure all parts are
properly assembled before allowing children to use the playground
equipment.
