XCEL Q-SERIES, Руководство пользователя

Страница: 23 / 33

23
o
A tethered output pigtail is included on some models and exits the front. The
connection description for this type of circuit is as follows:
Charger Side Connector
Molex Connector Housing: 39-01-3029
Molex Connector Contacts: 39-00-0041 – Male Pin Contact
Circuit Connection: Circuit #1 (WHT in Charger Side Figure above)
Circuit #2 (BLK in Charger Side Figure above)
Vehicle/Equipment Side Connector
Molex Connector Housing: 39-01-3025
Molex Connector Contacts: 39-00-0039- Female Socket Contact
Circuit Connection: Circuit #1 (WHT in Vehicle Side Figure above)
Circuit #2 (BLK in Vehicle Side Figure above)
For Charger Side Pigtail Lockout Inhibit Cable Replacement, refer to the parts list

Products with a ‘ SEVEN(7)-CIRCUIT Front Output Connector’ :
o
Refer back to the section titled ‘Output Connector Circuit’ to locate the two
circuit pins that connect a Lockout (Inhibit) circuit
o
The main output connector from which the Battery Output Lead originates
may have 4 contacts or 6 contacts Pin or Socket type installed. Each Pin or
Socket Contact is known as a ‘circuit’.
o
Disconnect the output lead from the charger, look inside the connector and
count the number of circuits. If there are 6 circuits, then 2 of them are
reserved for creating a Lockout Inhibit Control Plan.
o
The Charger Side Connector will have the Lockout Inhibit Circuit connected
to the Pin contacts:
Circuit #4: WHT in Vehicle Side Figure above – Lockout Positive
Circuit #7:
BLK
in Vehicle Side Figure above – Lockout Negative
o
The following options are available to implement the Lockout Function:
 Option One – This option may have already been installed. Your output
cable may already have the extra leads to implement the Lockout
Function and is connected to your vehicle’s lockout mechanism
 Option Two – Where the Output Connector and Cable do not have an
additional set of output leads for the Lockout Inhibit Control function:
 Contact the factory or your supplier or DPI’s web site,
www.DPIpower.com for additional information regarding Lockout
(Inhibit) Cabling and Kit configurations and purchase

These options may require you to disassemble the backshell on the
cable connector, install a pig-tail Lockout Cable
 Contact Factory and speak with Customer Service concerning various
premade cable assemblies that can fit your product