Xantrex Watt Series Programmable DC Power Supply XG 850, Руководство по эксплуатации

Страница: 46 / 286

Local Operation
3-2 M370078-01
Introduction
Once you have installed the power supply and connected both the AC
input power and the load (covered in “Installation” on page 2–1), the
power supply is ready for local operation. To turn the power supply on,
see “Powering the Power Supply On/Off” on page 2–8.
Configuring Settings from the Front Panel
Using the 9-Position Mode Control
The 9-position mode control is used with the rotary Adjust/Enter control
to configure settings in local operation. See Figure 1-2, “Front Panel
Display and Controls” on page 1–5 for location of the front panel
features.
Using the 9-position mode control, select one of nine modes: VOLTS,
AMPS, FLD, PRT, SAV, RCL, CAP, and VAP. See Figure 3-1 and Table
3-1 for detailed information on the nine modes.
Using the Rotary Adjust/Enter Control
The rotary Adjust/Enter control is used to change settings and set the
value selected. The front panel displays information on the output voltage
and output current displays. Each display has a maximum of four
characters that are made up of 7 segments.
Figure 3-1 9-Position Mode Control