Xantrex Freedom X 2000, Руководство пользователя

Страница: 50 / 92

Basic Installation Procedures
36 Freedom X 2000 - 230V Owner's Guide
Step 8: Testing Your Installation
WARNING
ELECTRIC SHOCK HAZARD
Pressing the Power button to turn the Freedom X inverter to
Standby on the display panel does not disconnect DC or AC input
power to the Freedom X. If shore power is present at AC input
terminals, it will pass through to the AC output.
Failure to follow these instructions can result in death, serious
injury, or equipment damage
.
There are two tests to be performed. The first test verifies that the
Freedom X is inverting DC battery power and delivering AC power
to its output.
The second test is intended for installations where AC input and
output is hard wired to the Freedom X. This test verifies that the
Freedom X transfers from inverter power to shore power when
shore power is present.
NOTE : Shore power (pass-through) refers to the AC input power
from a utility grid, generator or external AC source.
When you are ready to test your installation and operate the
Freedom X, close the DC fuse and Disconnect or the DC circuit
breaker to supply DC power to the Freedom X.
Testing in Battery Mode
To test the Freedom X:
1. For hard wired installations, ensure shore power is not
present.
2. Press the Power button to turn the inverter on.
The green status indicator LED for Battery mode (Inverter
mode) is illuminated. See
Status LED Indicators on page 42 .
3. Plug a test load, such as a lamp within the power rating of
the inverter into an AC outlet hard wired to the Freedom X.
4. Turn the lamp on to verify that it operates.
If the lamp operates, your installation is successful. If your
installation has AC input and output hard wired to the Freedom X,
proceed to
Testing in Grid Mode .
If the status LED on the display panel glows red, see the
Troubleshooting chapter.