28
Freedom SW 230V Installation Guide
Installing the Inverter/Charger
5. Connect the line and neutral wires to the output terminals
(labeled AC Output on the terminal block, Figure 6 on
page 26) as follows:
Connect Line to
OUTPUT L
, Neutral to
OUTPUT N
.
6. Tighten the terminal screws. Leave some slack wire
inside the wiring box.
7. Connect the ground wires to a free position on the ground
bus, Figure 6 on page 26. If solid ground wire is being
used, the wire can be connected directly under the screw
heads. If stranded ground wire is being used, ring
terminals must also be used.
8. Secure the strain-relief clamp on the AC output cable
jacket.
9. Attach the wiring compartment cover panel and tighten
the four screws.
10. Connect the outgoing AC wires to an AC load panel
equipped with circuit breakers.
FSW 230V Installation Guide.book Page 28 Tuesday, August 7, 2018 9:18 AM