11
Controllers
Smart Pad
3
TO PM110
®
TO EM110
L+
L–
R–
R+
SPEAKER
OUTPUT
L+
L–
R–
R+
AMPLIFIER
INPUT
PM110
SMART PAD
3
PROGRAMMABLE MODULE
+12V
IR OUT
ST
A
TUS
GND
TM
® SYLMAR, CA MADE IN U.S.A.
20-Conductor Ribbon Cable & Plug Ass'y (supplied with EM110)
PM110
(Rear)
EM110
(Rear)
Red Stripe
Red Stripe
Fig. 10
3-Gang EM110 to PM110 Connections
selections on CD, Channel selection on SAT & VCR, etc., on
their respective banks.
3. The
TNR
,
TNR
buttons for the AM/FM Tuner can also serve as
Channel Up/Down for SAT & the VCR TV tuner.
4. Use the 2nd tier on the TUNER button for AM/FM selection,
if desired.
Programming a Three Gang
Configuration
1. When you have completed the assembly of the buttons and
the modules and have installed them into the PM110 &
EM110 as shown in
Fig. 9
, connect them together with the
ribbon cable as shown in
Fig. 10
. Locate
red stripe
side of
cable as shown.
2. You can now program this configuration in the same manner as described in the procedures on pages
9 through 11.
3. When you have completed all programming, you can
transfer
this whole command set to any number
of additional keypads (identically configured), as needed, in multi-room installations. Refer to the
"
Command Transfers
(Cloning)" section.
BUTTON AND MODULE ASSEMBLY
The key module assemblies have been designed specifically so that they can be custom configured with
the desired button arrangements. To assemble, disassemble, change and reassemble, as desired,
proceed as follows:
Assembly
Fig. 11
Typical Key Module Assembly
Rubber
Actuators
Key Module
Shell
Rear
Tab
Cursor
Buttons
Retainer
Tabs
18-Pin
Connector
Key Module
PCB & Base
Retainer
Slots
Function
Keys
Bank
(Source)
Buttons
1. First, decide on the buttons you need and their locations (see
examples on pages 8,12 & 17).
2. Pick up the
Key Module PCB & Base
assembly and carefully
push each
button
onto the
Rubber Actuators
in the locations
you desire. Refer to
Fig. 11
.
(As received from the factory, the key module shell is separate
from the key module PCB & base assembly).
3. When the buttons are completely in place, pick up the
Key
Module Shell
and lower it over the
Key Module PCB & Base
assembly. (
Figs. 11 & 12
).
Key Module
Shell
Key Module
PCB & Base
Rear
Tab
Front
Tab
Assembled
Buttons
Fig. 12
Assembly of Key Module Shell
4. Move the buttons slightly, as necessary, to align them so
that they pass through the button openings in the
Key
Module Shell
.
5. Carefully press the
Key Module Shell
down until the 4
small
Retainer Tabs
(
Fig. 11
) on the
Key Module PCB
& Base
assembly
snap into the corresponding
Retainer
Slots
on the
Key Module Shell
.
6. Mount the completed key module into the PM110 (or
LM110 or EM110). Place the
Front Tab
on the module
under the
Small Lip
of the PM110. Align the
18-pin plug
with the
18-pin socket
and carefully push into place. See
Fig. 13
.
