20
©2013 XAircraft All Rights Reserved.
Fail-safe Setting
Set Fail-safe on radio to make the receiver outputs “safe mode on” signal for Flight Controller
when RC signal is lost.
Check
: After setting fail-safe, should power on SuperX and turn off the transmitter, then the LED
shows Safe Mode. If LED does not indicate Safe Mode, please check radio settings again.
About Home Position
1.
If GPS has good signals before take-off, the home position is the place where motors started.
2.
If GPS no signals before take-off, the home position is the place where GPS gets enough
satellites to work.
Get Back the Control
If the RC Signal is normal, turn off the Safe Mode by switch, you will get back the control of
flying immediately.
RC signals is back to normal, if throttle is not at lowest level and the Safe Mode switch is OFF,
you will get back the control of flying.
Notice: If GPS lost signals during returning to home, SuperX will auto land immediately.
