16
©2013 XAircraft All Rights Reserved.
4.
Keep sticks at neutral point, fast altering Flight Mode switch until led solid green, calibration
done.
5.
Repower on.
RC Reverse Calibration
1.
Fast altering Flight Mode switch between modes. When LED flashing red and green, the
controller enters Calibration Mode.
2.
Push both sticks to top right as diagram shows, the LED show triple green flashing.
3.
Keep
both sticks on top right, fast altering Flight Mode switch until led solid green, calibration
done.
4.
Repower on.
Flight Control
Motor Start / Stop
Follow diagram as below: Push sticks both
down-inside
or
down-outside
to start motors, then
motors are running slowly. If the motors do not start after the operation, please check wiring of
receiver and reverse setting of radio.
