X-lite X-903 Ultra Carbon 29, Инструкции по безопасности и эксплуатации

Страница: 23 / 116

23
X903
LINER POSITIONING CONTROL (LPC)
1
ADJUSTING THE POSITION OF THE LINER
The different anatomic shape of the rider’s head at times requires to adapt the position
of the helmet to the head in question. Thanks to the LINER POSITIONING CONTROL
(LPC), you can adjust the position of the liner which, considering the same size of the
helmet, allows to change the positioning of the helmet on the head with respect to the
standard one, adapting to various needs.
To adjust the liner, proceed as follows after releasing the rear part of the liner (see
instructions above).
1.1 Release the liner adjustment rear flap from the central locking pin on the rear frame
of the liner (Fig.20).
1.2 Pull the adjustment rear flap and hook it to the central pin in one of the other 7
possible snap positions.
By pulling the adjustment rear flap of the liner, the helmet is gradually posi-
tioned higher on the head snap after snap.
1.3 Fully reassemble the liner into the helmet (see instructions above) being careful to
correctly insert the adjustment flap into the cavity between the outer shell and the
polystyrene inner shell.
1.4 Wear the helmet and ensure that the positioning and comfort suit your head. Oth-
erwise, adjust once again.
WARNING
After adjusting the position of the liner, wear and fasten the helmet to check the correct
adjustment of the chin strap (see attached label), the correct positioning of the helmet
on the head in the riding position and the taking off (see “SAFETY AND USE INSTRUC-
TIONS” above).
EYEWEAR ADAPTIVE
1
OPENING SPACE FOR GLASSES
1.1 Remove the left cheek pad from the helmet (see instructions above).
1.2 Remove the expanding foam inner padding of the cheek pads (see instructions
above).
1.3 Remove the top part of the inner pre-punched inner padding (Fig.21), then correct-
ly put back the remaining padding part into the cheek pad.
It is recommended to keep the removed padding for any subsequent reuse.
1.4 Reassemble the expanding foam inner padding of the cheek pads (see instruc-
tions above).
1.5 Reassemble the complete cheek pad on the helmet (see instructions above).
1.6 Repeat the same operations with the right cheek pad padding
2 CLOSING SPACE FOR GLASSES
2.1 Remove the left cheek pad from the helmet (see instructions above).
2.2 Remove the expanding foam inner padding of the cheek pads (see instructions
above).
2.3 Properly insert part of the previously removed padding into the fabric lining of the
cheek pad (Fig.21).
INSTRUCTIONS FOR USE