Operati
on manual X-O
NE -
UPDATE 2018
www.x-dreamfly.ch
5. Maintenance and inspection of the X-ONE
Before each packing the parachute must be inspected by a packer. Was the emergency parachute opened for an
emergency case then the rescue must be subjected from the manufacturer.
Behaviour if damaged
If a check at the rescue system found some damage which affect the airworthiness of the device, the rescue
equipment has to be send to the manufacturer for repair. This also applies to damages whose impact on the
airworthiness of the system and cannot be uniquely determined.
Storage
A rescue device exists to save the life of the owner. It needs careful maintenance and care. UV radiation, moisture
and chemicals are the worst enemies of your X-ONE rescue device. Avoid unnecessary burdens and let your
X-ONE never unnecessarily lying in the sun. The rescue equipment should be dried in clean, dry and dark rooms.
Rescue packages that are no longer used should be stored loosely rolled in a bag.
Cleaning and drying
Dirty canopies and containers can be washed with clean clear water. Acids and mildew can affect the strength of
the components. Such polluted parachutes have to be sent to the manufacturer for investigation and repaired if
necessary.
Repairs
The manufacturer or authorized X-dream Fly Partners must perform all repairs.
Correct disposal of the rescue equipment
As an environmentally conscious manufacturer of rescue equipment we pay great attention to produce our pro-
ducts Eco social tolerated. The material we use in our products is evaluated according to environmental criteria
and subject to constant control. For the proper disposal the steel fittings should be separated at the metal
disposal point. The canopy, the lines and straps can be disposed with household waste.
6. Attachment to the harness
Each new combination of harness and rescue has to be checked
(Compatibility Check)
after the first packing by the
manufacturer of the harness or by a trained and appointed person. Deploying the rescue system has to be possible
out from each flying position according with the requirements of the building regulation. It should be noted that
the release force of 7daN is not exceeded. The X-ONE must be connected with a carabiner or by looping through
the V-line to the harness. When using a connection carabiner the breaking load of the carabiner must have a min.
of 2400 daN.
page 11 of 32
