Wyrestorm MX-0808-HDBT, Инструкция по эксплуатации

Страница: 12 / 24

13
Technical Support: support@wyrestorm.com US: +866 677 0053 EU: +44 (0) 1793 230 343
ADV
AN
CE
D OPE
RA
TI
ON
Index Setting details Index Setting details
1 0db/0db 17 23db/0db
2 0db/-3db 18 23db/-3db
3 0db/-6db 19 23db/-6db
4 0db/-9db (defult) 20 23db/-9db
5 10db/0db 21 25db/0db
6 10db/-3db 22 25db/-3db
7 10db/-6db 23 25db/-6db
8 10db/-9db 24 25db/-9db
9 16db/0db 25 26db/0db
10 16db/-3db 26 26db/-3db
11 16db/-6db 27 26db/-6db
12 16db/-9db 28 26db/-9db
13 19db/0db 29 27db/0db
14 19db/-3db 30 26db/-3db
15 19db/-6db 31 26db/-6db
16 19db/-9db 32 26db/-9db
Press the
OBJ (object)
button to select the output port you want
to adjust and then choose the equalisation mode you would like to
use. Press
OK
to apply the adjustment.
The modes are as follows:
Note: If you encounter picture flicker, we recommend setting
Index 1 - 0db/0db.
Info Mode
In addition to an illustrattion of the current matrix settings for the 8
inputs over the 8 outputs, the
Info menu
also states details of any
amendments made to EDID, LC, IR or IP settings.
Note: A
red dot
next to an output illustrates that the
corresponding RJ45 output port is in single output mode.
switch
save
observe
preview
setting
A
C
MS
EQ
M1 M2 M3
switch
save
observe
preview
setting
A
C
MS
EQ
M1 M2 M3
switch
save
observe
preview
setting
A
C
MS
EQ
M1 M2 M3
Calibrating screen sensitivity
Should a loss in touch screen sensitivity become noticable, we
recommend recalibrating the screen by pressing and holding the
SETTING
button in the
HOME MENU
until the system enters
calibration mode, revealing a blank screen with a
small blue icon
in the bottom left corner.
Press and hold the centre of the
icon until it disappears and
reappears in another part of the screen. Repeat process until the
calibration ends with an
OK message and the screen is ready for
use. Should you see a FAILURE message, repeat the process
with care taken to press the centre of the icon.
If repeated attempts to calibrate the screen continue to generate
FAILURE messages, contact your authorised WyreStorm dealer
for assistance.
Press and hold the
SETTING
button to exit calibration mode
MS
- shows the current state of the matrix
M1, M2, M3
- shows pre-saved configurations
EQ
- view current equalisation settings