8
Technical Support: [email protected] US: +1 866 677 0053 EU: +44 (0) 1793 230 343
Front Panel Control
Basic switching of various source inputs to output
displays can be achieved via the front panel control of the
MX0404-QI.
Outputs are numbered 1 – 4 with an input select button
to the left. Repeated pressing of the select button of a
specific output scrolls through the HDMI input devices
connected to the matrix, with the corresponding LEDs
illustrating when a device has been selected for that
particular output. The chosen input will automatically
store for the output so, even when the matrix is powered
off and on, on resumption the last selected input/output
combination will remain.
Attention
Users will notice a brief flicker on
screen when switching between inputs/outputs
– this is normal for this model and represents the
matrix resetting device HDCP settings to allow
communication from a different device. For constant
HDCP when switching with no noticeable screen
resets, see WyreStorm PRO, Pro Plus and HDBaseT
matrix ranges. See www.wyrestorm.com for more
information
The same basic functions can also be accessed via the
remote control. Operation of the handset is the same
regardless of location – locally (source/IR emitter) or
remotely (display/IR receiver).
Simply toggle through the input sources connected to the
matrix by either pressing the left/right arrow buttons or
buttons numbered 1 – 4 for each output.
Remote Control (Local IR)
Select specific
source numbered
1-4
Toggle numerically
forwards/backwards
through connected
source devices
Install battery ‘+’ side up
and only use CR 2025 3V
batteries. Slide
compartment back into
the handset.
Output port number
To change handset
battery
1
2
3
4
1
1
2
3
4
2
1
2
3
4
3
1
2
3
4
4
Pinch here and pull out
Switch on the power to your input sources, displays,
and any display receivers used. Finally, power up the
MATRIX. Your MX0404-QI should now be fully connected
and ready for use.
Remember, always switch off the matrix before
unplugging any inputs or outputs – follow last on, first off
protocol.
If your IR emitters and receivers are correctly placed
you should now be able control your sources from each
individual display location.
If there is electrical interference or cable bends/kinks
within the set up the IR is one of the first functions to fail.
If you do not have IR control:
• Check your cables are straight with jacks firmly
connected to ports. • Check your IR sensors are
unobstructed and able to receive infrared signals.
• Check direct sunlight on the emitters/receivers is not
affecting the infrared signal.
8
9
10. Basic Operation
BASIC OPERA
TION
