15
Technical Support: [email protected] US: +1 866 677 0053 EU: +44 (0) 1793 230 343
Click
to assign the new IP address to the system and you will
return to the previous screen or
to return without changes taking effect.
Now click
for the Matrix to detect the new IP address, which will
appear in the dialog box. Finally click
to confirm IP settings
Attention
This ‘Assign IP’ process differs from the
COM CTL ‘IP Set’ function.
‘Set IP’ in COMCTL saves/reads the IP address
in flash and sets it as static IP. ‘Assign IP’ is only
used when the system fails to obtain an IP address
automatically and is NOT saved in flash.
MX0404-QI - EDID DIP Switch setting
Distribution of HD signals through the matrix requires
mutual communication or ‘handshake’ between source
and display. If there is any disparity between the two,
successful transmission becomes problematic.
This matrix comes equipped with an EDID DIP switch on
the rear panel for manual adjustment of matrix settings to
encourage communication between INPUT and OUTPUT
devices. If installation compatibility issues arise, check the
settings on your connected devices and adjust the DIP
settings as required.
Attention
Changes to the DIP switch settings
should be made with the matrix OFF, ideally with
all power cables and HDMI leads and UTP cables
removed to guard against electrostatic build up that
may damage your system. DO NOT HOTSWAP your
cables when changing DIP SETTINGS.
ALL changes to the DIP settings become effective
upon powering ON the matrix.
EDID Copy from Output display to Input
port (Force Signal Output mode)
To copy the EDID from an OUTPUT display
to a specific INPUT port, first set the DIP
switch to this position. Then select the INPUT by pressing
and holding the chosen OUTPUT SELECT button for 3
seconds for the EDID to be copied from the DISPLAY to
the INPUT port.
Select the INPUT you wish EDID to be copied onto.
PRESS and HOLD the OUTPUT SELECT button for
3 seconds for the OUTPUT EDID to be copied to the
selected INPUT
1080p 3D Video / Stereo Audio (using
embedded M-series EDID) FACTORY
DEFAULT
Setting the DIP switch to this position will
instruct the matrix to use embedded 1080p 3D video
and Stereo audio to encourage communication between
the matrix and 3D sources/3D displays if handshake
problems are encountered.
After setting the DIP switch, reconnect and turn on for the
changes to take effect.
RESETTING TO FACTORY DEFAULT:
As 1080p-3D-Stereo is the default factory setting for the
matrix, to reset EDID of all ports, simply set the DIP switch
to the above position when the matrix is powered OFF. On
powering ON, all ports will revert to 1080p-3D-Stereo and
DIP switches can be adjusted as necessary.
1080p Stereo (using embedded A-series
EDID)
The matrix will use embedded 1080p video
and stereo audio in this DIP setting.
After setting the DIP switch, reconnect and turn on for
EDID settings to take effect.
1080i Stereo (using embedded L-series
EDID)
In instances where a connected display is
unable to achieve 1080p resolution (such
as using older or cheaper models), this DIP setting will
instruct the matrix to use embedded 1080i video and
stereo audio to output a signal.
After setting the DIP switch, reconnect and turn on for
EDID settings to take effect.
ADV
ANCED OPERA
TION
