Wylie Defender 3 Pt Sprayer, Руководство оператора и каталог запасных частей

Страница: 19 / 34

15
Connecting 12 Volt Pump to Power
The 12 volt Remco pump is an on-demand pump that will
automatically shut off when the discharge valve is closed.
The pump can be wired permanently with a toggle switch
to turn power on or off to the pump (red wire is positive (+),
black wire is negative (-)).
Installing the Flat Fold Boom
The Utility Skid may be equipped with an optional Flat
Fold boom that mounts in the receiver hitch of a pickup or
utility vehicle.
Insert the boom mount into the vehicle receiver hitch,
then slide the boom over the boom mount and pin at the
desired spraying height. Tighten the spreader bolt on the
boom mount to remove any slack inside the receiver hitch.
Tighten the jam nut.
Fit the supply hose to the “T” hosebarb and secure with
a hose clamp.
Your Wylie Utility Skid Sprayer was manufactured to the
highest standards of quality. It is necessary though, to
check to make sure that nothing was damaged during
shipping. Check bolts and fasteners for tightness. Check
the pump and plumbing for any signs of damage.
Utility Skid Sprayer Inspection & Setup
Your Wylie Utility Skid Sprayer was completely assembled
and should not need any additional assembly before use.
The 50 or 100 gallon Utility Skid Sprayer can be mounted
in a pickup or utility vehicle and is equipped with “L” bracket
tiedowns. The four tiedown brackets and hardware are
bagged and shipped inside the tank.
Set the skid in the desired location in the bed of the vehicle,
mark and drill ½” holes in the bed and the skid frame. Install
and tighten the nuts and bolts.
Utility Skid Sprayer Inspection and Setup
Figure C2
Utility Skid Tiedown
< Tiedown Bracket
Figure C4
Flat Fold Boom Receiver Hitch Mounting
Red (Po) Wire >
< Black
(Negative -) Wire
< Pressure Switch
< Receiver Hitch
< Boom Mount
Boom Mount Tube >
Figure C3
12 Volt Pump Wiring
Figure C1
Utility Skid Sprayer
< “T” Hosebarb
< ½” Supply Hose
Utility Inspection & Setup