Würth EPM 160-E, Перевод оригинальной инструкции по эксплуатации

Страница: 14 / 149

14
Intended Use
This hand-guided orbital polisher is intended for com-
mercial use in industry and trade. It is intended for all
types of polishing work, such as for coated surfaces on
vehicles, for furniture, metal and stone surfaces using
polishing sponges, lambskin and wool pads, for oper-
ation with polishing tools approved for speeds of at
least 500 rpm.
For damage caused by usage other than intended, the
user is responsible.
Product Features
1 Gear housing cover
2 Handle
3 Spindle lock button
4 Gear head
5 Type plate
6 Lock-on button
7 On/Off switch
8 Thumbwheel for speed adjustment
9
Allen key
10 Velcro plate
11 Mains cable
Not all of the accessories illustrated or described
are included as standard delivery.
Tool Specifications
Before Starting Operation

Before any work on the machine itself,
pull the mains plug.
Dismounting the Handle
(see figure A)
Loosen the screws with Allen key 9 and remove the
handle 2 .
Mounting the Gear Housing Cover
(see figure B)
Loosen the screws with Allen key 9 , remove the handle
2 and the gear housing cover 1 .
Slide the gear housing cover 1 on again and fasten it
with the screws.
Mounting/Exchanging Polishing
Tools (see figure G)
Place the polishing tool centrally on the Velcro plate
10 and firmly press it on.
Plug the mains plug into the power socket and switch
the power tool on.
Start a test run to check for imbalance and vibrations.
Exchanging the Velcro Plate (see
figure H)
Remove the polishing tool.
Press the spindle lock button
3 and loosen the screw
using Allen key 9 . Actuate the spindle lock button 3
only when the power tool is completely stopped.
Replace the Velcro plate
10 . The groove of the Velcro
plate 10 must engage in the spanner flats of the drive
shaft; if required, lightly rotate the drive shaft.
Press the spindle lock button
3 and tighten the screw
again using Allen key 9 .
Start a test run to check for imbalance and vibrations.
Operation

Observe the mains voltage! The voltage of
the power source must correspond with the data on
the type plate of the machine.
Orbital polisher EPM 160-E
Article number 5707 500 X
Rated power input 1010 W
Output 590 W
Speed range 160 – 480 rpm
Orbital rate 3200 – 9600 rpm
Dia orbit 8 mm
Tool holder Ø 140 mm
Application tool diameter 160 mm
Weight 2.7 kg
Class of protection II
OBJ_BUCH-0000000218-002.book Page 14 Thursday, August 20, 2015 10:47 AM