WUNDER SA.BI.SRL USER MANUAL
AGS INOX REV.01 04/12/2016 5
5. INSTRUCTION FOR USE
5.1 BEFORE WEIGHING
Make sure that:
a.
The stainless steel platter is placed correctly on top of load receptor.
b.
The scale is placed on a level and strong surface.
c.
The scale is turned on.
d.
The ZERO INDICATOR is on. If not, press ON/ZERO to set display to zero.
5.2 WEIGHING
a.
Always place an object onto the platter gently. Excessive force applied to platter may cause damages to sensor
inside scale.
b.
The weight of the object would be displayed automatically.
c.
It is a good practice to remove all loads from platter after weighing. It would prolong the lifetime of scale.
5.3 SELECT WEIGHT UNIT
Press MODE to shift between metric or avoirdupois weight units. The weight unit used before power off would be
employed when the is turned on again.
NOTE:
To comply with the law of certain countries and certain approval requirements, the avoirdupois weight units may be
disabled. Contact your dealer for more information.
5.4 SET BACKLIGHT
Follow the below steps to turn on and off backlight (if purchased).
a.
Scale is on
b.
Press and hold ON/ZERO until backlight is activated; or press MODE to shift between metric and avoirdupois
weight to turn on and off backlight
5.5 SMART POWER SAVING FUNCTION
The backlight function will turn off when constant/zero weight is detected and remains stable for about 20/10 seconds.
Backlight will be automatically turned on again when a new weight is detected.
5.6 SET DISPLAYED VALUE TO ZERO WHEN UNLOADED
By pressing ON/ZERO, a positive or negative weight displayed will be set to zero and ZERO INDICATOR appears.
Refer to SPECIFICATIONS for maximum zero range.
NOTE:
-When scale is set at OIML and application is legal for trade. User only needs to press ON/ZERO once when setting the
value to zero. The re-zero function will take place when reading is stabled
-When scale is set at Non-OIML and application is not legal for trade. User can set the value to zero at anytime when
