User Manual
14
Quick Start Guide
•
Ensure that the battery is fully charged and the SD memory card is inserted in the camera
•
Keep button “On/ Off” depressed for 2 seconds to switch on the camera.
•
Wait till the boot screen image disappears and uncover lens cap. Non Uniformity Calibration (NUC) is performed automatically.
•
Aim the camera at the target.
•
Rotate the W/T wheel manually to adjust the focus to get clear thermal image or you can press the W/T wheel to get clear thermal image
automatically.
•
Press
button
“
☼
”
and release it instantly and then adjust Tmax, Tmin and palette if necessary.
•
Press
button
“
PIC Mode
”
to switch to live visual image and fusion image.
•
In visual image, still rotate the W/T wheel to manually focus or you can press the W/T wheel to get clear visual image.
•
Press
button
“
PIC Mode
”
for 2 seconds to switch between manual and auto modes.
•
Press button “OK” for three seconds to freeze the live image.
•
Press button “OK” for three seconds again to store the frozen image into SD memory card or built-in flash memory of the camera.
•
Press button “C” to return to the live thermal image.
Using the Camera
Powering on the camera
Keep button On/ Off depressed for 2 seconds to power on the camera.
Then the loading image and boot-up flash as shown below appear on the screen.
After the boot-up flash disappears, live image as shown below is displayed, with Guide logo and temperature setup menu lying at the right side
of the screen.