IAD100T Advanced Configuration Manual
Wuchuan Network Tech Co., Ltd
www.5111soft.com
18
Configuration Explanation:
Configure Web browser port, the default is 80 port, if you
want to enhance system safety, it is best to change it into non-80 standard port, after subit save
configuration, please notice re-login the way should be http://xxx.xxx.xxx.xxx
：
xxxx/
Configure Telnet port, the default is 23.
Enable RTP initial port configuration. It is dynamic
allocation.
Configure the maximum qunantity of RTP port. The default
is 200.
Lease IP-MAC correspondence table of
DHCP.
Note: The configuration on this page needs to be saved after modified and will go into effect after
restrating. If the Telent, HTTP port will be modified, it is the best to set as greater than 1024,
because the 1024 port system will save ports. Set the HTTP port as 0, the HTTP server will be
unable.
2.4.4 Firewall config
Configure the open input and output firewall on this page, the firewall input and output rules can be configured at
the same time, for enhance safety, these configurations can be used to prevent some malicious IP to visit gateway.
Accesslist is a simple similar visit to Cisco control list (firewall) module. This function supports two rules: the
rules of input and output rules. Each rule will be assigned a serial number. The maximum allocation is 10 rules.
