IAD100T Advanced Configuration Manual
Wuchuan Network Tech Co., Ltd
www.5111soft.com
12
usually this blank is empty no need to fill in.
Configure local SIP signal port, default port is
5060(this port will go into effect immediately; the SIP call will use the modified port for
communication after modification).
Configure SIP register expire time, the default
is 60 seconds. If the server requests the register time more or less than configuration time, the
gateway can automatically modifty it to recommended tiem limits and registers.
Configure detect interval time, if gateway
enables SIP detection interval function, the gateway will detect once for whether the server has
response every other detection interval time.
Configure RFC protocol edition. When the gateway need
to communicate with gateways which is using CISCO5300 with SIP1.0, then it should be
configured into RFC2543 to communicate normally. The default is to enable RFC3261.
DTMF sending mode configuration, three kinds:
the different service provider may provide the different mode.
Configure Auto Dect Server.
Enable / Unable register.
Enable / Unable support SIP pack.
Enable / Unable Signal Encrypt.
Enable / Unable RTP Encrypt
Enable / Unable keep authentication, in this way the devices does
not need to do the authentication with the server each time any more, server receives register
request with Authentication then will directly send back the confirmative message;
Enable / Unable support RFC4028
Enable / Unable SIP default protocol
2.3.2 IAX2 config
