WTI APS-16M, Руководство пользователя

Страница: 35 / 82

5-19
Confi guration
To select common parameters for all APS-8/16M RS-232 ports, proceed as
follows:
1. Access command mode. If the password prompt is displayed, key in a
password that permits Supervisor Mode.
2. At the command prompt, type
/CP
and press
[Enter]
, the menu shown in
Figure 5.7 will be displayed.
3.
Selecting Parameters:
To select parameters to be copied, key in
the number for the desired parameter, press [Enter] , then follow the
instructions in the submenu. Note that it is not necessary to define all port
parameters, for example, the /CP command could be used to select only
the Baud Rate for all ports.
4.
Clear Menu:
After defining several parameters, if you wish to clear the
/CP menu and start again, type
-
(dash) and press
[Enter]
, the menu will
be reset.
5.
Exit Without Copy:
To exit from the Copy Parameters menu without
copying selected parameters to all RS232 ports, type
X
and then press
[Enter] . The APS-8/16M will exit from the Copy Parameters menu and
return to the command prompt.
6. Copy Parameters: When you have finished selecting parameters, press
[Esc]
to copy the selected parameters to all APS-8/16M RS-232 Ports and
exit from the Copy Port Parameters menu. Note that the APS-8/16M will
display a "Sure" prompt before copying parameters to other ports.
5.7. Save User Selected Parameters
Although this step is optional, it is strongly recommended to save all user-
defined parameters to an ASCII file. This will allow quick recovery in the
event of accidental deletion or reconfiguration of port parameters. Section 9
describes the procedure for saving configuration parameters to an ASCII file.