Wouxun KG-UV2D, Руководство пользователя

Страница: 10 / 17

Select required channel to alter
Make required channel parameter changes
Restart to exit dealer mode:
MENU A/B MENU
5 Standby, Scanning, Reverse, Monitor, and DTMF
“Standby” is used by Wouxun to refer to watching activity on both frequencies (dual receive) when in dual frequency or dual channel modes,
“Scanning” is an automatic frequency/channel change to detect busy frequencies, “Reverse” refers to receiving the transmit frequency of a repeater
input and “Monitoring” means to open the squelch temporarily to listen to a weak signal. How scanning behaves is dependent on the mode.
5.1 Standby (Dual Receive)
When in dual frequency or dual channel mode the master frequency is indicated with an ► arrow at left of the chosen frequency/channel. However,
the radio is also watching the secondary (sub) frequency. If the master frequency is clear signals detected on the sub frequency break through and an
S
is displayed in the upper right of the LCD display. If you do not require this dual receive behaviour switch to single frequency/channel mode with
TDR
. In single frequency/channel mode UVxx is displayed in place of a second frequency or channel – where “xx” is the radio model number.
5.2 Scanning
Ensure frequency step is appropriate:
MENU 1 MENU
▲ (until correct step is selected),
MENU EXIT
To scan in either VFO, Channel or FM Radio Mode:
SCAN*
(long press)
To change scan direction: ▲ or ▼
To tune to a frequency or channel: ▲ or ▼ (long or short press, or
ROTARY
)
To set scan type:
MENU 1 9 MENU
▼ to select
TO/CO/SE
scan type,
MENU EXIT
TO = time out scan - continues scanning if no operations 5 seconds after receiving a signal
CO
= carrier out scan - pauses when receiving signals and continues 3 seconds after no signal
SE
= search scan - scanning stops when a signal is received
Note that these Wouxun radios do not have VFO mode scan limit edges.
10