Lithium-Ion cordless circular saw EN
11
drilled.
The tool being in good condition and well
maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING:
To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration and noise
exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
ACCESSORIES
WX529
WX529.9
TCT 24T Blade
1
1
Dust adapter
1
1
Hex Key
1
1
Parallel guide
1
1
20V 2.0 Ah Li-ion battery
(WA3551.1)
1
/
1hr charger(WA3860)
1
/
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to
the accessory packaging for further details. Store
personnel can assist you and offer advice.
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the
instruction book carefully.
INTENDED USE:
The tool is intended for ripping and cross-cutting
wood and other materials in straight cutting lines,
while resting firmly on the work piece.
ASSEMBLY AND OPERATION
Action Figure
BEFORE OPERATION
Removing the battery pack
See Fig. A1
Charging the battery back
See Fig. A2
Installing the battery pack
See Fig. A3
ASSEMBLY
Saw blade Assembly and
Removing
WARNING:
Always
remove the battery
before changing the blade!
See Fig. B
Hex key storage
See Fig. C
Safety On/Off switch
WARNING:
To avoid
cutting injury from the
sharp blade, please don’t put
your hands around the Base
Plate.
NOTE:
Keep the dust adapter
connected to dust collecting
device when using the tool.
See Fig. D
Cutting depth adjusting
See Fig. E
Cutting guide
See Fig. F
Parallel guide
See Fig. G1, G2
Bevel cuts
See Fig. H
Sawdust removal
See Fig. I
WORKING HINTS FOR YOUR
TOOL
If your power tool becomes too hot, please run your
circular saw no load for 2-3 minutes to cool the
motor. Avoid prolonged usage at very low speeds.
Protect saw blades against impact and shock. Cutting
with extreme force can significantly reduces the
performance capability of the tool and reduces the
service life of the saw blade. Sawing performance
and cutting quality depend essentially on the
condition and the tooth count of the saw blade.
Therefore, use only sharp saw blades that are suited
for the material being cut.
Choice of blades: 24 teeth for general work, approx.
40 teeth for finer cuts, more than 40 teeth for very
fine cuts into delicate surfaces, diamond for tile,
cement board, etc.
Only use saw blades recommended.
