Worx WX473, Инструкция по безопасности и эксплуатации

Страница: 5 / 17

Jigsaw WX473 WX473.1 WX474
14. After long working period, external metal
parts and accessories could be hot.
15. Only withdraw the blade from the cut when
the blade has been stopped moving.
16. The pivoting blade foot must be held firmly
against the material being cut to reduce
saw vibration, blade jumping and blade
breakage.
17. Before cutting, check the cutting line is free
of nails, screws, etc.
18. If possible, ensure the work-piece is firmly
clamped to prevent movement.
19. Never stop the cutting blade by applying
side pressure to the blade.
20. Your Jigsaw is a hand held tools, do not
clamp your Jigsaw.
WARNING: Some dust particles
created by power sawing, contain
chemicals known to cause cancer, birth
defects or other reproductive harm.
Some examples of these chemicals are:
• Lead from lead-based paints.
• Crystalline silica from bricks and cement
and other masonry products.
• Arsenic and chromium from chemically
treated lumber.
Your risk from these exposures varies,
depending upon how often you do this type
of work. To reduce your exposure to these
chemicals:
• Work in a well-ventilated area.
• Work with approved safety equipment,
such as those dust masks that are specially
designed to filter microscopic particles.
GENERAL SAFETY
WARNINGS FOR YOUR
LASER (ONLY FOR WX474)
WARNING: Read all safety warnings
and all instructions.
Failure to follow
the warnings and instructions may result in
serious injury.
Save all warnings and instructions for
future reference.
These lasers do not normally present an
optical hazard although staring at the
beam may cause flash blindness.
Do not stare directly at the laser beam. A
hazard may exist if you deliberately stare
into the beam, please observe all safety
rules as follows:
1. The laser shall be used and maintained
in accordance with the manufacturer’s
instructions.
2. Never aim the beam at any person or
an object other than the work piece.
3. The laser beam shall not be
deliberately aimed at another person
and shall be prevented from being
directed towards the eye of a person
for longer than 0.25 seconds.
4. Always ensure the laser beam is
aimed at a sturdy work piece without
reflective surfaces, e.g wood or rough
coated surfaces are acceptable.
Bright
shiny reflective sheet steel or similar is
not suitable for laser applications as the
reflective surface may direct the laser beam
back at the operator.
5. Do not change the laser device with
a different type.
Repairs must be carried
out by the manufacturer or an authorized
agent.
6. CAUTION: Use of controls or
adjustments other than those
specified herein may result in
hazardous radiation exposure.
Additional safety warning for class 2
laser
The laser device fitted to this tool is
class 2 with a maximum radiation of
1mW and 650nm wavelength.
CLASS 2 LASER RADIATION, DO NOT
STARE INTO BEAM